LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Where to hook up a performance programmer?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=9289		 Page 1 of 1
Author:  Endurance [ Wed Jun 07, 2006 11:12 am ]
Post subject:  Where to hook up a performance programmer?
Hello everyone,

I will be getting my SP Diesel module tomorrow and was wondering where I have to hook up the cables? I started searching and saw that many connectors look pretty much the same. I think I narrowed it down to 4 possible connectors though. If someone could tell me where the performance module will plug in, that would be perfect.

Image

Image

Image

Thanks
Author:  TurboC5 [ Wed Jun 07, 2006 7:13 pm ]
Post subject: 
Image

The SP module has 2 connectors and a ground that go into the engine bay. They plug into the map sensor #1 and the fuel pressure sensor #2. As you asked me in the PM, the SP has a small connector at the little hand held box that you can pass through the firewall. It's very easy.

I've been testing mine and here's what I've found so far. Even in the fuel economy mode it has more power than stock and seems to be getting at least 10% better mileage. And the EVIC seems pretty close to right on when it's in fuel economy mode. But when you crank it up to the higher performance settings, the EVIC starts to get way off. In fact in the highest setting the EVIC will jump 8-10MPG better than what it's getting.
Author:  Endurance [ Thu Jun 08, 2006 1:05 am ]
Post subject: 
Thanks alot! Thats what I needed. Did you get the connector that goes to the handheld box through the existing hole thats already in the firewall? The one right by those connectors?
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/