FreedomKJ wrote:
When doing mods like this be very careful to make sure you're using a wire gauge that can handle the maximum amp draw that your inverter/amp/whatever will pull, plus a little extra for safety. Also be sure to use a fuse that is big enough to handle that draw, but smaller than what your wiring can handle.
Failing to follow these guidelines is likely to leave you standing on the side of the road watching the pretty lights on the firetrucks.
With that said, mod away!!
Good to know, thanks for that.
For the power wire I matched the gauge but for the really thin wires that I needed to extended I used a slightly thicker gauge, I believe it was 24. I left the fuse the same so I am good.