Hi All - Well it took some time but the bumper "mounting base" is completed and installed. I will be putting the whole jeep back togather later today (baby sitting my 2yo son). Here are some pics. You can see all the pics at
http://www.big808.com/coppermine/
the site needs work but its a start
Went from 6 standard stock size bolts to 4 - 1/2" grade 8s with top plate
the bolt will hold the actual bumper, the hole will hold the changable shackle/hitch. Im thinking of using the smaller size hitch reciever built into the bumper. Hard to explain.
Prepped the uni frame with spray rustolium
I figure this the plate as a huge washer it will not pull out of the thin uni frame
Now I can start working on a bumper thats easilly removable. I may cut the whole bottom of the plastic factory bumper off. Not quite sure yet - More ispiration from then Prerunner style bumper ORM.
Auggy, Rocky and all thanks for looking and commenting. I love doing this stuff, Im just slow tring to get it right by myself. Was a auto mechanic for a few years but Never done this stuff b4.