Working on fabbing up my own set of side sliders and wondering if there is a drawback to
welding to the frame as opposed to drilling and bolting other than the fact that removal for repair would be a lot harder ..
Also to the pinch weld ...weld it there too
I know not too much heat:twisted: in one place and watch for warping but if you took the time and did this is there really a disadvantage .....
Somebody at somepoint had to have had a POS truck that they just said ":-)r
F@&# IT:-)r
" in a drucken stooper and done this .......
so what are the pros and cons to this installation
thankyou all for your time and input
_________________
http://www.cardomain.com/ride/30098032004 Limited (Rescue Jeep)
2 1/2 daystar lift 235/70/16
{Electric Stuttertone Emergency Horn}
strobe leds front and rear
2 way VHF radio (kenwood)
westin brush guard+ Hella 500's w/ 100w 3000k bulbs
back seat removed and shelf added
rolled and totaled dec 4 2010..(drunk driver)