So, a few folks here have the custom-run of front hitch receivers based on one of the hidden-hitch (I think) designs (with the steel loops for safety chains, etc.). Does anyone have the drawings of said project (I can't find any technical references to it, only that it was done a couple years back and only used ones are floating around).

I'm thinking of ways to do the mounting for front push/bull bar and recovery attachments and this vs. a chopped-up Detours backbone seem to be in the lead for feasibility, and I'm thinking building a partial receiver frame will be cheaper than buying a backbone and (gasp) chopping it all up.

Dan

_________________

2005 Silver CRD Limited
245/75R16 GoodYear Duratracs
Fumoto drain | ProVent CCV Filter
Stanadyne FM100 filter | Cummins fuel pump
GDE Eco | SEGR | BoulderBars | FrankenLift | Frankenskids

You might contact Landy (username) as he is the one who did the custom run. Looks like he is still active, his last visit was a week ago.

Yep. I PMed him and got no response. Just testing the waters to see if anyone else had some details.

_________________

2005 Silver CRD Limited
245/75R16 GoodYear Duratracs
Fumoto drain | ProVent CCV Filter
Stanadyne FM100 filter | Cummins fuel pump
GDE Eco | SEGR | BoulderBars | FrankenLift | Frankenskids

search for his threads, I thought he posted up some drawing with measurements on them.

_________________
1980 Jeep CJ7 Buggy
SOA, D44/ FF14B, SBC 350, SM465, NP205, 108" WB, 37" MTs

http://www.dpgoffroad.com/
http://www.ucora.org/
http://www.christianoffroad.com/
http://jeepinbyal.com/

Dan, PM me as I have book marked the blue prints for the front hitch.........

_________________
2008 KK Liberty Sport NIGHT OPS EDITION + GILLS
OEM & Custom Skids - Factory Tow Package - Rock Lizard Skink Super Sliders
Prototype JBA 4 Inch Lift - JBA UCA's - Flowmaster Super 44 OR - Whacked Resonator
Jet Stage 2 - RL Gecko Basket Rack - Custom Winch Bumper - Recon 10.5K Winch