LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

My 2005 Liberty Renegade
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=6&t=1155
Page 1 of 1

Author:  JAMSKJ [ Mon Aug 15, 2005 4:43 pm ]
Post subject:  My 2005 Liberty Renegade

Here is my Liberty loaded with 4 mtn bikes and gear, preparing for a mtn bike ride to the beach (74 km). The Liberty followed as the support car!

Image

John

L.O.S.T. #000573
http://www.cardomain.com/ride/838929
2005 Liberty Renegade
MOPAR offroad package
MOPAR roof rack
BAUER rear tire bike rack
mods:
GRACO baby seat (wife's mod!)
PIAA driving/fog lights; custom front bumper lightbar
mag light seat mount
Superflow air compressor (under rear seat)
BAUER rear tire bike rack

Author:  carroll952 [ Mon Aug 15, 2005 8:46 pm ]
Post subject: 

gotta love that blue!


Justin

Author:  Steakgoddess [ Tue Aug 16, 2005 4:07 pm ]
Post subject: 

Nice.

Author:  Tokyojoe [ Tue Aug 16, 2005 7:52 pm ]
Post subject: 

SWEET!


But,



Next time, make the Wrangler be the support vehicle.....LOL! :lol:

Author:  FloridaKJ [ Wed Aug 17, 2005 6:48 pm ]
Post subject: 

I like. Where did you find the light bar for the front of the KJ? I have been looking for something like that and have had no luck.

Thanks,
Scott

Author:  benstudley [ Wed Aug 17, 2005 6:57 pm ]
Post subject: 

I beat him to it:

http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=678

Author:  FloridaKJ [ Wed Aug 17, 2005 7:17 pm ]
Post subject: 

I saw these pics as well. I would like to know where to get the light bar!

Scott

Author:  JAMSKJ [ Thu Aug 18, 2005 7:04 pm ]
Post subject:  2005 front bumper lightbar

Hey guys!
The light bar I had built. It is really very simple in design. I had two rounded rectangular steel pieces (hollow) welded at an angle to account for the slightly curved front end and bolted this to the existing light mount tabs using existing offroad light mouting bolt. I had to have three spacers (each side) cut to lift the bar up off the bumper. You can see the spacers in one of the install pics. The two existing factory offroad lights mount with the screw down so I just had two holes drilled in the new bar. The two square lights mount with the bolt horizontal so I had two "L" tabs welded on just to the inside on the mounting screws to the bumper.
I little rewiring on the existing light harnesses and all is good to go.

http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=678

L.O.S.T. #000573
http://www.cardomain.com/ride/838929
2005 Liberty Renegade
MOPAR offroad package
MOPAR roof rack
BAUER rear tire bike rack
mods:
GRACO baby seat (wife's mod!)
PIAA driving/fog lights; custom front bumper lightbar
mag light seat mount
Superflow air compressor (under rear seat)
BAUER rear tire bike rack

Author:  Neatus [ Thu Aug 18, 2005 8:39 pm ]
Post subject: 

Looking good!

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/