Here is my Liberty loaded with 4 mtn bikes and gear, preparing for a mtn bike ride to the beach (74 km). The Liberty followed as the support car!



John

L.O.S.T. #000573
http://www.cardomain.com/ride/838929
2005 Liberty Renegade
MOPAR offroad package
MOPAR roof rack
BAUER rear tire bike rack
mods:
GRACO baby seat (wife's mod!)
PIAA driving/fog lights; custom front bumper lightbar
mag light seat mount
Superflow air compressor (under rear seat)
BAUER rear tire bike rack

gotta love that blue!


Justin

_________________
2005 Blue KJ Renegade
Too big to fit into most LA parking garages.

Nice.

_________________
Sandie
2002 KJ

SWEET!


But,



Next time, make the Wrangler be the support vehicle.....LOL!

_________________
===
New KJ Gear - Desert Armor Flak

2004 Renegade Light Khaki - 4" JBA Lift - Rock Lizard Products: Komodo Dragon Rear Bumper, Prototype Winch-mount Front Bumper, Super Skink Sliders - All J's Super Tranny Skid II - 31" Firestone Destination AT's on Moab wheels - Cobra 75W CB w/ stock Antenna mod

[b]Retired, US Military

I like. Where did you find the light bar for the front of the KJ? I have been looking for something like that and have had no luck.

Thanks,
Scott

_________________
05 KJ Sport
All Stock

I beat him to it:

http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=678

_________________
'05 Renegade - Lt Khaki
No mods yet!

I saw these pics as well. I would like to know where to get the light bar!

Scott

_________________
05 KJ Sport
All Stock

Hey guys!
The light bar I had built. It is really very simple in design. I had two rounded rectangular steel pieces (hollow) welded at an angle to account for the slightly curved front end and bolted this to the existing light mount tabs using existing offroad light mouting bolt. I had to have three spacers (each side) cut to lift the bar up off the bumper. You can see the spacers in one of the install pics. The two existing factory offroad lights mount with the screw down so I just had two holes drilled in the new bar. The two square lights mount with the bolt horizontal so I had two "L" tabs welded on just to the inside on the mounting screws to the bumper.
I little rewiring on the existing light harnesses and all is good to go.

http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=678

L.O.S.T. #000573
http://www.cardomain.com/ride/838929
2005 Liberty Renegade
MOPAR offroad package
MOPAR roof rack
BAUER rear tire bike rack
mods:
GRACO baby seat (wife's mod!)
PIAA driving/fog lights; custom front bumper lightbar
mag light seat mount
Superflow air compressor (under rear seat)
BAUER rear tire bike rack

Looking good!

_________________