All in all not too bad on the install. Took about 4 hours which included bike rides to the laundry mat, many trips in the house for beers, and straightening my crossmember a little because of the fender bender I was in.

_________________
Pre-Lowered 02 Liberty
2.5" Rustys Coil w/ Ranchos in the rear.
ARB, OME927's, 1/4 strut plate and Als Gen 4.5 Uppers in the front.
Flowmaster Super 40 Series (GONE, SO QUIET!)
245/75/16 Kumho KL-78 w/ Spidertraxxxxx
Ripped out the plastic inner wheel liners
Herculined ALLLL over.....

i like it. especially those lined flares and quaterpanel!

Is it me or are you missing 2 bolts(circled in white)? Those 2 bolts are important to keep the alignment and provide 2 more bolts holding the bumber shell on.

Lookin good though!!!!

Yes, those are not installed yet. Thatll get done tomorrow afternoon. I did this afterwork the other day so I skipped it for a few days.... Next thing to get will be the spidertrax!

_________________
Pre-Lowered 02 Liberty
2.5" Rustys Coil w/ Ranchos in the rear.
ARB, OME927's, 1/4 strut plate and Als Gen 4.5 Uppers in the front.
Flowmaster Super 40 Series (GONE, SO QUIET!)
245/75/16 Kumho KL-78 w/ Spidertraxxxxx
Ripped out the plastic inner wheel liners
Herculined ALLLL over.....

_________________
Sun, Sand, Surf, Freedom and LIBERTY!! Who can ask for more??

'02 Limited 4x4 (since 07/01)
Rene light bar
ARB Bumper
Warn XD9000
Hella Comet 500 lights
255/70R16 Rusty's 2.5" coil lift
Al's arms
2" receiver
Surco rack