It is currently Fri Dec 26, 2025 1:32 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 8 posts ] 
Author Message
 Post subject: Finally respectable enough to get a pic up
PostPosted: Tue Feb 07, 2012 8:50 pm 
Offline
LOST Member
User avatar

Joined: Mon Sep 26, 2011 4:35 pm
Posts: 178
Location: Brooklyn, NY
So after 4 long months the jeep has graduated from being a soccer moms grocery getter and is now worthy of its first pic post.

Image

_________________
05 CRD Limited
GDE Hot Tune
Samco CAC Hoses
OME 790 and Bilstein 916 up front
OME 948 and OME N132L in rear
245/75/16 Treadwright Warden A/T on Richard Cepek DC-2
Euro torque converter
Renegade roof lights
Pioneer Z110bt double din navi w/ reverse cam

Image


Top
 Profile  
 
 Post subject: Re: Finally respectable enough to get a pic up
PostPosted: Tue Feb 07, 2012 8:55 pm 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Fri Oct 07, 2011 12:15 pm
Posts: 153
Location: Brooklyn, NY Kunkletown, PA
nice Brooklyn CRD, one day I will get one of my gasser up.

_________________
2002 KJ Limited 3.7
Completely Stock
215/85R16 Kevlar


Top
 Profile  
 
 Post subject: Re: Finally respectable enough to get a pic up
PostPosted: Wed Feb 08, 2012 6:08 pm 
Offline
LOST Addict
User avatar

Joined: Sun Feb 15, 2009 8:23 am
Posts: 1218
Looks sick....I got a thing for 05 Lifted Light Khaki Limited's....
Image

_________________
05 KJ Limited 4x4 in Light Khaki: Detours USA Backbone, Warn M8000, Huskyliners, RockLizard Super Skink sliders, OME/Bilstein Lift, JBA UCA's, 245/70/17 Nitto Terra Grapplers
07 LR3 SE V8
1996 XJ Country
2015 KL Limited


Top
 Profile  
 
 Post subject: Re: Finally respectable enough to get a pic up
PostPosted: Wed Feb 08, 2012 8:20 pm 
Offline
LOST Newbie

Joined: Mon Oct 18, 2010 4:16 pm
Posts: 37
Sick rig it's very respectable :rockon:

_________________
07 light khaki 4x4 KJ Frankenlift II Baja JBA 4.5 UCAs


Top
 Profile  
 
 Post subject: Re: Finally respectable enough to get a pic up
PostPosted: Thu Feb 09, 2012 10:32 am 
Offline
LOST Newbie
User avatar

Joined: Fri Dec 23, 2011 7:47 pm
Posts: 96
how did you go about trimming your front bumper? i bought i utility knife for mine is that strong enough to cut through the plastic?


Top
 Profile  
 
 Post subject: Re: Finally respectable enough to get a pic up
PostPosted: Thu Feb 09, 2012 10:55 am 
Offline
LOST Member
User avatar

Joined: Mon Sep 26, 2011 4:35 pm
Posts: 178
Location: Brooklyn, NY
dejesu wrote:
how did you go about trimming your front bumper? i bought i utility knife for mine is that strong enough to cut through the plastic?


I marked my lines off with electrical tape and then followed the edge with a dremel cutoff wheel on the lowest speed. If you go higher, it just melts the plastic. I would go half way through in about 6 inch sections to make the line nice and straight, then i would go back and finish the cut through. There was a section on each side where the wheel was too small to go through. i used a sawzall metal blade and my hand to cut through. I kept the cut further from the finished line because it was a rough cut. When it was all off, i went back in with the dremel sanding wheel to clean up the edges. I'm thinking i should co back in and clear coat the edge and polish it out before the factory clear starts peeling up from that point.

_________________
05 CRD Limited
GDE Hot Tune
Samco CAC Hoses
OME 790 and Bilstein 916 up front
OME 948 and OME N132L in rear
245/75/16 Treadwright Warden A/T on Richard Cepek DC-2
Euro torque converter
Renegade roof lights
Pioneer Z110bt double din navi w/ reverse cam

Image


Top
 Profile  
 
 Post subject: Re: Finally respectable enough to get a pic up
PostPosted: Fri Feb 10, 2012 12:55 am 
Offline
LOST Newbie
User avatar

Joined: Fri Dec 23, 2011 7:47 pm
Posts: 96
if it's not too much to ask, can you possible post an under-bumper shot? i just want to make sure i don't mess up when i cut... i can't destroy my bumper haha


Top
 Profile  
 
 Post subject: Re: Finally respectable enough to get a pic up
PostPosted: Thu Feb 23, 2012 12:25 am 
Offline
LOST Member
User avatar

Joined: Thu Jul 05, 2007 12:50 am
Posts: 179
Location: liberty, mo.
It's addictive, Nice wheels! I like the look....

Here's mine..

Image
By daveinliberty at 2012-02-06

_________________
2006 Liberty Sport CRD
GDE FT ECO/HOT Tunes.
OME 2.5
265 70r 16
SC Bumper
Glass Pack
Provent
Dodge 2500 in tank Lift pump
Samco Hoses
Rocky Road UCA
Transgo shift kit
Updated torque converter
Weeks Kit 1 & 2


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 8 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 14 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com