So after 4 long months the jeep has graduated from being a soccer moms grocery getter and is now worthy of its first pic post.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Finally respectable enough to get a pic up http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=6&t=65099 |
Page 1 of 1 |
| Author: | spitfire36o [ Tue Feb 07, 2012 8:50 pm ] |
| Post subject: | Finally respectable enough to get a pic up |
So after 4 long months the jeep has graduated from being a soccer moms grocery getter and is now worthy of its first pic post.
|
|
| Author: | fratichelli [ Tue Feb 07, 2012 8:55 pm ] |
| Post subject: | Re: Finally respectable enough to get a pic up |
nice Brooklyn CRD, one day I will get one of my gasser up. |
|
| Author: | HoosierJeeper [ Wed Feb 08, 2012 6:08 pm ] |
| Post subject: | Re: Finally respectable enough to get a pic up |
Looks sick....I got a thing for 05 Lifted Light Khaki Limited's.... 
|
|
| Author: | jaarr76 [ Wed Feb 08, 2012 8:20 pm ] |
| Post subject: | Re: Finally respectable enough to get a pic up |
Sick rig it's very respectable 
|
|
| Author: | dejesu [ Thu Feb 09, 2012 10:32 am ] |
| Post subject: | Re: Finally respectable enough to get a pic up |
how did you go about trimming your front bumper? i bought i utility knife for mine is that strong enough to cut through the plastic? |
|
| Author: | spitfire36o [ Thu Feb 09, 2012 10:55 am ] |
| Post subject: | Re: Finally respectable enough to get a pic up |
dejesu wrote: how did you go about trimming your front bumper? i bought i utility knife for mine is that strong enough to cut through the plastic? I marked my lines off with electrical tape and then followed the edge with a dremel cutoff wheel on the lowest speed. If you go higher, it just melts the plastic. I would go half way through in about 6 inch sections to make the line nice and straight, then i would go back and finish the cut through. There was a section on each side where the wheel was too small to go through. i used a sawzall metal blade and my hand to cut through. I kept the cut further from the finished line because it was a rough cut. When it was all off, i went back in with the dremel sanding wheel to clean up the edges. I'm thinking i should co back in and clear coat the edge and polish it out before the factory clear starts peeling up from that point. |
|
| Author: | dejesu [ Fri Feb 10, 2012 12:55 am ] |
| Post subject: | Re: Finally respectable enough to get a pic up |
if it's not too much to ask, can you possible post an under-bumper shot? i just want to make sure i don't mess up when i cut... i can't destroy my bumper haha |
|
| Author: | LIBERTYinLIBERTY [ Thu Feb 23, 2012 12:25 am ] |
| Post subject: | Re: Finally respectable enough to get a pic up |
It's addictive, Nice wheels! I like the look.... Here's mine..  By daveinliberty at 2012-02-06 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|