There are a variety of introductions or descriptions of the remote control code scanner, however, the information of how to use the scanner is very little. Here I have listed the steps to use the scanner based on different functions.

For receiption function
1. Turn on the power supply.(Display of Remote control Decode the tool)
2.Press any key on the remote control receiver to receive. (Display the remote control password)
3.Press the fifth key of the host to save the password, you can save thirty yards, more than thirty, it will automatically flush the code stored in the beginning.

For transmission function
1.Press the first and second key of the host.(Display Remote co01001 Decode the too S)
2.Press the fifth key of the host to get the code saved on last turn, rember that you should press the times according to the number of code.
3.Press any of the first four keys to transmit code.
4.Attention: if you have changed the code for transmission yourself, you can press any of the first four keys to adjust, then press the fifth key to transmit.

For scanning function
1.Press the keys once in the turn of the fifth, the second, and the fifth to begin scanning
2.The fifth key of the host is to pause, after pause, we can adjust the vibration resistance and address code.
3.The code state can list as follows:
Dimorpic code: 0, 1
Three-state code: 0, 1, 2
0, 1, 2, 3
4.The Working frequency range of the scanner includes 315MHZ and 433MHZ.



All the above is the most completed conduction of operate the scanner up to now, to summerize these information, I have tried in different ways. Kindly hope this will help friends run into the same problem like me.