It is currently Sun Jul 12, 2020 12:07 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 9 posts ] 
Author Message
 Post subject: Extra half inch of lift
PostPosted: Sat Oct 22, 2016 1:46 am 
Offline
LOST Newbie

Joined: Fri Sep 09, 2016 8:24 pm
Posts: 47
Location: Montreal, Quebec
Good evening everyone,

Quick question, adding a 0.5 inch to my 2 inches. For the front, JBA offers 1/4 inch plates but for the back, what would be the best solution?

Also, for 2.5 total inches of lift, I believe the upper arms would not be required, am I correct?

Thx everyone.

Marcos


Sent from my iPad using Tapatalk


Top
 Profile  
 
 Post subject: Re: Extra half inch of lift
PostPosted: Sat Oct 22, 2016 2:29 am 
Offline
Lifetime Member
Lifetime Member
User avatar

Joined: Sun Feb 01, 2009 2:29 am
Posts: 5956
Location: Hillsborough, NC / Petersburg VA
rear, extra isolator(s), a piece of kitchen cutting board, etc whatever you want to use

for the front, get the plates and then you can add a conduit nut later to level it some if necessary/post settling

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632


Top
 Profile  
 
 Post subject: Re: Extra half inch of lift
PostPosted: Sat Oct 22, 2016 11:16 am 
Offline
Moderator / Lifetime Member
Moderator / Lifetime Member

Joined: Thu Jul 07, 2005 5:49 pm
Posts: 27226
Location: NOW Southeastern Ohio/ Tanzania
For the rear we all usually use extra iso's . Use one extra upper on each side for 1/2 inch lift

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited


Top
 Profile  
 
 Post subject: Re: Extra half inch of lift
PostPosted: Sun Oct 23, 2016 2:11 am 
Offline
LOST Newbie

Joined: Fri Sep 09, 2016 8:24 pm
Posts: 47
Location: Montreal, Quebec
Thank you for the info. Greatly appreciated. Now need to know if I require the jba upper arms but I am almost sure I do not. Thx


Sent from my iPhone using Tapatalk


Top
 Profile  
 
 Post subject: Re: Extra half inch of lift
PostPosted: Wed Oct 26, 2016 8:25 am 
Offline
LOST Newbie

Joined: Fri Sep 09, 2016 8:24 pm
Posts: 47
Location: Montreal, Quebec
What is the difference between the coil spring seat and coil spring insulator on a front liberty strut?


Sent from my iPad using Tapatalk


Top
 Profile  
 
 Post subject: Re: Extra half inch of lift
PostPosted: Wed Oct 26, 2016 12:18 pm 
Offline
Moderator
Moderator
User avatar

Joined: Sat Aug 24, 2013 11:36 pm
Posts: 5570
Location: Central GA
marcos wrote:
What is the difference between the coil spring seat and coil spring insulator on a front liberty strut?
Sent from my iPad using Tapatalk

Item No. 17 in Factory Chrysler Parts calls it an "Isolator"...

#17 ISOLATOR.
Lower, Right or Left, Upper, Upper or Lower. Spring.. LCA to Cradle, Upper or Lower.
ISOLATOR. Spring. Upper or Lower. . "Suspension - Normal Duty"+"Spring - Left Front". Required: 002
ISOLATOR. Spring. Upper or Lower. . "Suspension - Normal Duty"+"Spring - Right Front". Required: 002
52088686AA

Image

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited :JEEPIN:
Ironman Springs/Bilstein/shocks
Yeti StgIV Hot Tune
Sasquatch BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox
GM11 bld. fan/NAPA HDclutch
IronrockArms/wwdieselMount


Top
 Profile  
 
 Post subject: Re: Extra half inch of lift
PostPosted: Wed Oct 26, 2016 6:17 pm 
Offline
LOST Newbie

Joined: Fri Sep 09, 2016 8:24 pm
Posts: 47
Location: Montreal, Quebec
So a seat or isolator is the same thing right? Just the rubber pieces that the spring goes in between


Sent from my iPhone using Tapatalk


Top
 Profile  
 
 Post subject: Re: Extra half inch of lift
PostPosted: Wed Oct 26, 2016 8:20 pm 
Offline
Moderator
Moderator
User avatar

Joined: Sat Aug 24, 2013 11:36 pm
Posts: 5570
Location: Central GA
marcos wrote:
So a seat or isolator is the same thing right? Just the rubber pieces that the spring goes in between
Sent from my iPhone using Tapatalk

Correct!

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited :JEEPIN:
Ironman Springs/Bilstein/shocks
Yeti StgIV Hot Tune
Sasquatch BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox
GM11 bld. fan/NAPA HDclutch
IronrockArms/wwdieselMount


Top
 Profile  
 
 Post subject: Re: Extra half inch of lift
PostPosted: Wed Oct 26, 2016 11:26 pm 
Offline
LOST Newbie

Joined: Fri Sep 09, 2016 8:24 pm
Posts: 47
Location: Montreal, Quebec
Perfect, ordered them this afternoon.


Sent from my iPhone using Tapatalk


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 9 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com