| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Springs for a ZJ http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=67&t=52690 |
Page 1 of 1 |
| Author: | WickedKJ [ Thu May 13, 2010 9:56 am ] |
| Post subject: | Springs for a ZJ |
Anyone know where I can get 4" springs for a zj? I am having a hard time finding that size. I find 4.5,3.5 and 5.5. If all else fails I will bump up to the 4.5. Also what springs(from other jeeps) can I use on the zj to get about the same height? Would 6" tj springs work for front and rear? Thanks |
|
| Author: | tjkj2002 [ Thu May 13, 2010 5:32 pm ] |
| Post subject: | Re: Springs for a ZJ |
Well if you need some new coils I do have a brand new set of RE 3.5 ZJ front coils,test fitted them on my KJ was all,zero miles and where only installed for 30mins max.If you don't have the V8 they'll give you 4" of lift at least. |
|
| Author: | WickedKJ [ Thu May 13, 2010 9:25 pm ] |
| Post subject: | Re: Springs for a ZJ |
My zj is a 4.0 v6. I run 33's so as long as I can get at least 4" out of a coil I would be ok. The springs on this jeep are shot. How much are you looking to get for them? Did they work on the kj?? lol |
|
| Author: | tjkj2002 [ Thu May 13, 2010 9:37 pm ] |
| Post subject: | Re: Springs for a ZJ |
WickedKJ wrote: My zj is a 4.0 v6. I run 33's so as long as I can get at least 4" out of a coil I would be ok. The springs on this jeep are shot. How much are you looking to get for them? Did they work on the kj?? lol You should have no issues with the RE's getting you 4" of lift,there rated for 3.5" for the V8 ZJ's,I know the 3.5" ZJ coils give 5"-5.5" of lift on XJ's.They worked but just to short,needed the 4.5" RE ZJ coils.Looking for $100 plus shipping. |
|
| Author: | WickedKJ [ Mon May 24, 2010 10:05 am ] |
| Post subject: | Re: Springs for a ZJ |
Just so happens the springs may not be bad. Looks like the prior owner has them installed on the wrong side causing it to lean to the passenger side. I will keep your springs in mind if this is not the case. Trying to get the control arm issue fixed and the axle fixed. 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|