LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Wheel cylinder
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=68&t=44746		 Page 1 of 1
Author:  Burchie [ Sat Jul 04, 2009 4:28 pm ]
Post subject:  Wheel cylinder
Wheel cylinder

OK. I got all the shoes and springs off. But I can't get the brake line to come loose from the cylinder. It just willn't budge and i'm slowly rounding the nut thingy. Any ideas before i grab it with the vise grips and go to town?
Author:  JJsTJ [ Sat Jul 04, 2009 5:08 pm ]
Post subject: 
soak in pb blaster and wait while you consume a 6 pack. if still won't budge, try a little heat and repeat.
Author:  Burchie [ Sat Jul 04, 2009 5:21 pm ]
Post subject: 
Who has PB Blaster? Pep boys? Heard of it, but never seen it.
Author:  JJsTJ [ Sat Jul 04, 2009 5:36 pm ]
Post subject: 
might need to hit a lowes or home depot?
Author:  yazhi [ Mon Jul 06, 2009 4:34 pm ]
Post subject: 
Burchie wrote:
Who has PB Blaster? Pep boys? Heard of it, but never seen it.



NO.....Jiffy......with just a lil jelly :twisted:
Author:  JJsTJ [ Mon Jul 06, 2009 4:47 pm ]
Post subject: 
how'd ya make out w/ this Burch?
Author:  Burchie [ Mon Jul 06, 2009 6:27 pm ]
Post subject: 
jeep is back and the ground and rolling. And even stopping too. :lol:

I never got it off. I soaked it, hit it, tried talking dirty to it, but nothing. no love. ..... what were we talking about again...... :shock:

BUt that side wasn't leaking so I cleaned it all up and put on new shoes, springs and it runs great. The leaking side I was able to remove and replace that cylinder. cleaned it all up, new shoes and springs. Bleed the brakes and off we went. peddle is still soft, but it stops.

After Roy gets done with all of Annette's little problems :lol: I'll run it up there and have him give it the once over and loosen my stuck stuff and then I'll replace the other cylinder.

tomorrow I go to the DMV.... :) :) :) :) :)
Author:  yazhi [ Tue Jul 07, 2009 5:06 pm ]
Post subject: 
Holy cow...make one comment about Peanut Butter :roll:

My "little" problems are solved and I will be on my way to Colorado on Friday :lol: Roy is all yours now Burchie :wink:
Author:  tools113 [ Thu Jul 08, 2010 9:34 pm ]
Post subject:  Re: Wheel cylinder
I had same problem - ended up breaking both break lines (right & Left) I don't think the system had ever been bled. Had to replace both wheel cylinders bleeders broke off. New break line and compression fittings now everything works great.

1999 XJ - 156,000 miles
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/