Does anybody have a service manual for the '03-'06 TJ's(rubicon)?If yes, would it be possible to get a copy or at least the wiring diagram for the vehicle speed sensor(the one on the t-case),need some info to see about a possible speedo fix for a KJ SFA swap that does not use the 8.25 in the rear.Thanks for any help you guy's can give me.

This is all i could find so far for a Speed sensor,


OPERATION
The VSS is a 3-circuit (3–wire), magnetic, hall-effect
sensor.
The 3 circuits are:
² A 5-volt power supply from the Powertrain Control
Module (PCM).
² A ground is provided for the sensor though a
low-noise sensor return circuit in the PCM.
² An input to the PCM is used to determine vehicle
speed and distance traveled.
The speed sensor generates 8 pulses per sensor
revolution. These signals, in conjunction with a
closed throttle signal from the throttle position sensor,
indicate a closed throttle deceleration to the
PCM. When the vehicle is stopped at idle, a closed
throttle signal is received by the PCM (but a speed
sensor signal is not received).
Under deceleration conditions, the PCM adjusts
the Idle Air Control (IAC) motor to maintain a
desired MAP value. Under idle conditions, the PCM
adjusts the IAC motor to maintain a desired engine
speed.

_________________
Richey

0IIIIII0
2006 IMPACT ORANGE RUBICON
305 Mt/Rs MT Classic II's
2.5 lift
1.25 JKS BL
JKS quicker Discos

PM SENT

_________________
Richey

0IIIIII0
2006 IMPACT ORANGE RUBICON
305 Mt/Rs MT Classic II's
2.5 lift
1.25 JKS BL
JKS quicker Discos

Thanks,you are a life saver(more like a money saver )!