i know tjkj and marty well recommned using the 77 and older ford hp44, since they dont have the cast radius wedge welded on them.

That is correct too hard to use the later model ones

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

there was nothing weld on it just a smooth axle and I will get some pic up to up date when I get back up to the shop to take some

JJ what do you use for the back for your coil lenght? to match the front coil over sizes ?

Just throwing this out there. A forklift has a hydrolic valve at the base of the steering column. Also it has alot of travel for the steer axel. if you were to find a junk fork lift would these pieces be of use? I really wish I could remember the name of that valve.....

_________________
SOLD!!!
2005 Liberty Renegade
STT CustomSTUFF
4" Stump Lift.
JBA UCA's
245/75/16 GOODYEAR DURA TRACS


Thanks for throwing me under the bus Evil... Just remember this when you decide to turn yours back in to a... Real Jeep.

sorry didn't see this sooner.

Not sure what the length/height is but here is the info:
Rear Springs, OME863, HD FJ80 – 2 ea. – $75.75ea

They are the OME mediums. Had heavys but ride was too stiff.

Had found the height info a while back but can't nail it down now.

_________________
99 TJ
71 C101
04 KJ
03 SFA KJ Sport
LOST JEEPS So-Cal

thanks looking in to doing that to start with it is going to be easyer and quicker for now till I get the rear work out to do the 4 link in the back
thanks just got my steering box it is a out of a 86 ford like new just need to clean it up will post pic soon

I see that PSC has come out with a high flow steering punp and it fit 86-96 cherokee and grand cherokee do you think it would work on the 3.7 and wopuld it be a good fit to the 86 steering box I have fot the SFA kit