so iv got a stock lift for now. if i do a lift im not going big at all. my question is.....

will these wheels fit with this back space? they are 15x8 what size tire would i be able to run with these wheels without scrub'n?

http://www.jegs.com/webapp/wcs/stores/s ... howValue=1

_________________
06 Cummins 2wd- industrial injection sliver bullet 66,pdi manifold,smarty(tnt tune),Dr. Performance predator w/ race tune,Fass 150/200,Goerend full billet trans,Pusher intake manifold,snow meth,boost fooler,cal tracs, Stage 2 AFE, about 9 isspros, II dual feed lines, wicked injection pump, mag hytec's, studs,spings and cam.

2005 CRD

stock bs is 5.5" 3.something is going to be rough, plus if they're alloy they aren't going to clear the calipers since they're 15" rims

peruse the tires section, there's a ton of discussion on 15" rims if that's the route you'd like to go, generally try to keep it between 4" and 5.5" bs

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632

thanks

_________________
06 Cummins 2wd- industrial injection sliver bullet 66,pdi manifold,smarty(tnt tune),Dr. Performance predator w/ race tune,Fass 150/200,Goerend full billet trans,Pusher intake manifold,snow meth,boost fooler,cal tracs, Stage 2 AFE, about 9 isspros, II dual feed lines, wicked injection pump, mag hytec's, studs,spings and cam.

2005 CRD

I have a stock XJ steelie 15" 5.5" of BS and it hits the tie rod ends so I think the least I'd shoot for is 5" of BS