LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

rubbing at the pinch weld..
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=8&t=28945		 Page 1 of 1
Author:  scarletbegonias [ Sat Jan 26, 2008 5:00 pm ]
Post subject:  rubbing at the pinch weld..
after i got the new meats on with the wheel spacers there was obvously trimming necessary however the guys that did it tried to pound down the pinch welds as far as they could but it's still rubbing them. I know that the tire tread will eventually wear and then it won't rub but in the meantime is there any suggestions on how to get the pinch weld more flat? (I hear grinding it down is no good..as it will eventually separate etc etc)
any thoughts, please shoot em on over..thanks!

and ps if you haven't seen my new setup, check it out in the pics section under "Goodbye Goodyears, Hello Grabbers" post :wink:
Author:  Guest [ Sat Jan 26, 2008 6:21 pm ]
Post subject: 
Maybe you just oughta remove the wheel spacers since they're causing you more trouble than they're worth? the spacers are the direct cause of all the rubbing and it's caused unnecessary hacking to your KJ that most of us don't have to worry about with 245/75-16s and a little lift...I didn't even have enough rub to warrant any pinch weld work with no lift and 245/75-16s

just my $.02...
Author:  ATXKJ [ Sat Jan 26, 2008 8:50 pm ]
Post subject: 
Official fix the Pinch weld thread
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=7690&highlight=pinch+weld
Author:  PaU-MWolverine [ Wed Jan 30, 2008 12:50 pm ]
Post subject: 
I don't run with spacers. I'd get rid of those first. But, with my slight rubbing, I had mine done. They ground of the pinch weld, then ran a bead of weld along it - as a precaution so the weld would not spread apart. When I got the KJ home, I sprayed it with undercoating. Hope this helps.
Author:  BostonJohn [ Wed Jan 30, 2008 3:22 pm ]
Post subject:  Re: rubbing at the pinch weld..
scarletbegonias wrote:
I know that the tire tread will eventually wear and then it won't rub but in the meantime is there any suggestions on how to get the pinch weld more flat?


Bigger hammer :twisted:
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/