LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
How To: Factory Center Caps on Cragar Soft 8's http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=8&t=34957 |
Page 2 of 2 |
Author: | infernicus [ Wed Jul 07, 2010 3:11 pm ] |
Post subject: | Re: How To: Factory Center Caps on Cragar Soft 8's |
Oooo, I like those center caps, can you get a close up of them? What Jeep did they come off of? |
Author: | Beowulf [ Mon May 25, 2015 9:14 pm ] |
Post subject: | Re: How To: Factory Center Caps on Cragar Soft 8's |
These look great. I plan on doing this with these center caps. This is the look I'm going for. |
Author: | tommudd [ Tue May 26, 2015 6:31 am ] |
Post subject: | Re: How To: Factory Center Caps on Cragar Soft 8's |
Beowulf wrote: These look great. I plan on doing this with these center caps. This is the look I'm going for. Make sure you get the right wheels, a lot of them are close but off just a little bit and will not work |
Author: | Beowulf [ Tue May 26, 2015 9:19 am ] |
Post subject: | Re: How To: Factory Center Caps on Cragar Soft 8's |
I'd like to hear more about the close but not quite part. I have not heard anything about that on other forums. What part is not quite right? Bolt pattern? The diameter of the center section where the cap goes? |
Author: | tommudd [ Tue May 26, 2015 9:35 am ] |
Post subject: | Re: How To: Factory Center Caps on Cragar Soft 8's |
Beowulf wrote: I'd like to hear more about the close but not quite part. I have not heard anything about that on other forums. What part is not quite right? Bolt pattern? The diameter of the center section where the cap goes? Bolt pattern Some are using wheels that have a bolt pattern of 5 X 115 (5 X 4.52) instead of the KJs 5 X 114.3 ( 5 X 4.5) Some will tell you its OK but in fact it will and does have to bend the studs a bit to actually tighten down which could lead to breakage of the studs I like the look as well and would have a set on mine if I could find ones with the right pattern, I won't risk using ones without correct bolt pattern |
Page 2 of 2 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |