| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| help on link http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=8&t=61275 |
Page 1 of 1 |
| Author: | irollgen4s [ Sat Jun 18, 2011 9:49 pm ] |
| Post subject: | help on link |
searched, couldnt find a definite answer. Im looking at getting D windows with 31' mud terrains. Found an awesome package, link provided below. 15x8 d windows with 31x10.5x15 BFG MT's. Im 90 percent sure the tires will fit fine with what i have cut since i've been running 265-70-16's.. Im wondering about the rims. I just want to know if they will clear the caliper without any issues on my CRD. http://www.ntwonline.com/31X10_50R15_BF ... 3C1340.cfm Thank you (probably tommudd  )
|
|
| Author: | RED_KJ_666 [ Sun Jun 19, 2011 7:00 pm ] |
| Post subject: | Re: help on link |
They don't say what the BS is on those wheels, that may be your issue 31's will be fine if you can already clear the 265's as even those BFG's don't measure full height. |
|
| Author: | irollgen4s [ Sun Jun 19, 2011 7:20 pm ] |
| Post subject: | Re: help on link |
well assuming its 5 inch backspacing. Im going to call them to set up an order and see if the backspacing is right as well. Just want to make sure that the 15 inchers clear the calipers. would the 31 BFG's be smaller then my 265s? i thought theyd be a tad taller/the same size. |
|
| Author: | RED_KJ_666 [ Sun Jun 19, 2011 9:57 pm ] |
| Post subject: | Re: help on link |
265/70/16 = 30.6x10.4/16 and Then keep in mind that most 31's are undersized anyways (My pro Comp X-A/T's measured 30.5") I had no problems on 31's at all with just the pinch welds smashed. 5" of BS might cause an issue with your TRE, I think you want to be around 4"-4.5" of BS. |
|
| Author: | irollgen4s [ Sun Jun 19, 2011 10:29 pm ] |
| Post subject: | Re: help on link |
with 8 inch rims you had to compensate with the backspacing i think. But i emailed JBA asking if they could get in D windows in 7 inches. Hopefully they can, would make this so much easier. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|