| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Siping MTR's? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=8&t=8915 |
Page 1 of 1 |
| Author: | DaveKJ02 [ Thu May 25, 2006 11:13 am ] |
| Post subject: | Siping MTR's? |
Anybody sipe their MTR's? I was reading about it on another forum but I'm not too familiar with it so I looked it up and found the link below. Supposedly helps them where more evenly and extends life? I dont get it-cutting helps? http://www.discounttire.com/dtcs/tireSiping.dos |
|
| Author: | kevh [ Thu May 25, 2006 5:22 pm ] |
| Post subject: | |
i havent done mtrs but i have done swampers in the past. it really helped tread wear and wet traction on the swampers. siping helps in 2 ways. first, all those tiny cuts help the tire run cooler. heat doesnt builup in the tread as bad so the tire runs ooler which makes it last longer second, in rain/snow/ice all those little cuts add surface area for traction. the cuts arent very deep and should really only be done on the center tread blocks. i have seen a little bit of chunking near the edges of the tread when the whole tread pattern was done. most places charge 10-15 bucks a tire so it may or may not be worth it to you. the added wet traction was really nice. most mud terrains and even the mtrs dont have very good wet traction due to the large treadblocks good ifo here... http://www.sipers.com/sipers/index_large.asp |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|