LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

door panel removal?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=44904
Page 1 of 1

Author:  Jeepin_it_real [ Fri Jul 10, 2009 10:18 am ]
Post subject:  door panel removal?

any how to's?... its quite difficult to locate the points where the clips are and actually get the panel off... any help would be greatly appreciated

Author:  Diggerfreek [ Fri Jul 10, 2009 2:03 pm ]
Post subject: 

1. Remove the door handle trim bezel (6).
2. Remove the fastener (5) from the handle area of the front door trim (4).
3. Use a very thin pry tool to remove the cap screw covers (3) from the front door trim (4).
4. Remove the screws (2) from the front door trim (4).
5. Remove the power window switch and disconnect the electrical connector.
6. Disengage the trim panel from the four way locator at the handle area of the trim panel, then carefully remove the door trim panel (4) from the door (1) by lifting upward until removed from the door lock and the mounting attachments on the carrier plate.

Image

Author:  Jeepin_it_real [ Fri Jul 10, 2009 6:56 pm ]
Post subject: 

thanks digger

Author:  Diggerfreek [ Fri Jul 10, 2009 7:01 pm ]
Post subject: 

No Prob 8)

Author:  Jeepin_it_real [ Mon Sep 21, 2009 7:50 pm ]
Post subject: 

hey digger where did you get the picture you posted above/// i wanted to increase the size btut it gets blurry so i bet i can get a better copy to enlarge form the original

Author:  Diggerfreek [ Mon Sep 21, 2009 8:09 pm ]
Post subject: 

It came from my FSM. I have tried to blow it up, but it can't get any where with it

Author:  Mike08Liberty [ Mon Sep 21, 2009 8:16 pm ]
Post subject: 

hope this helps ...

Image

Author:  Jeepin_it_real [ Mon Sep 21, 2009 10:18 pm ]
Post subject: 

indeed it does.. do you have a manual or some kind haha... you always have all these diagrams... where do i get me one of these manuals you got haha

Author:  Diggerfreek [ Mon Sep 21, 2009 11:41 pm ]
Post subject: 

:twisted: The Magical FSM (Factory Service Manual)


PM me and we will talk

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/