| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Stock Fording Depth http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=45973 |
Page 1 of 2 |
| Author: | BrendonR [ Wed Aug 19, 2009 11:43 am ] |
| Post subject: | Stock Fording Depth |
Anybody know how deep is too deep on our stock KKs? |
|
| Author: | Mike08Liberty [ Wed Aug 19, 2009 1:02 pm ] |
| Post subject: | |
In this video I was at stock height. To give you an example I have been in water that was about 6" deep then this. The water was rushing over the hood. http://www.youtube.com/watch?v=EG3hNOK4abQ You can get pretty deep, more will depend on how long you are going through the deep water. Obviously the longer you are crossing very deep water the more chance you have to have an issue. Just remember slow and steady and you should be OK for most water crossings. |
|
| Author: | greatoppressor [ Wed Aug 19, 2009 1:24 pm ] |
| Post subject: | Re: Stock Fording Depth |
BrendonR wrote: Anybody know how deep is too deep on our stock KKs?
That's a good question. I've seen an actualy depth specified by Jeep liturature for some other models, but not this one. Maybe I just haven't found it yet. -SR- |
|
| Author: | Boiler [ Wed Aug 19, 2009 1:27 pm ] |
| Post subject: | |
Is it in your manual? I don't remember the exact number...but I know the KJ manual stated what the depth was. I think 21". |
|
| Author: | hrogi [ Wed Aug 19, 2009 3:49 pm ] |
| Post subject: | |
I have never looked for it. But I think if you have a Trail Rated or Trail Tested badge it should be Documented... As that has to be 1 test... If I did water sport in my KK, I might set up a bozzer alarm tellme if I get with in 2 inches of the limit. |
|
| Author: | greatoppressor [ Wed Aug 19, 2009 3:53 pm ] |
| Post subject: | |
hrogi wrote: I have never looked for it.
But I think if you have a Trail Rated or Trail Tested badge it should be Documented... As that has to be 1 test... If I did water sport in my KK, I might set up a bozzer alarm tellme if I get with in 2 inches of the limit. That's not a bad idea. Since getting water in the airbox is probably the limiting factor of water fording depth (assuming breather tubes have been extended), you could maybe rig up something to let you know if you start to get water in the bottom of your airbox or when the water gets close to the bottom edge of the airbox intake. That wouldn't be very difficult. -SR- |
|
| Author: | hrogi [ Wed Aug 19, 2009 3:58 pm ] |
| Post subject: | |
most boat shops sell this kit for boats.. So it has to be easy to find.. Or even wire it to a Light. |
|
| Author: | Diggerfreek [ Wed Aug 19, 2009 10:05 pm ] |
| Post subject: | |
Should be 22 inches..... |
|
| Author: | Mike08Liberty [ Wed Aug 19, 2009 10:10 pm ] |
| Post subject: | |
22" ... I think I got that beat ... and this wasn't the deepest part
|
|
| Author: | Diggerfreek [ Wed Aug 19, 2009 10:32 pm ] |
| Post subject: | |
| Author: | Mike08Liberty [ Wed Aug 19, 2009 10:34 pm ] |
| Post subject: | |
Diggerfreek wrote: :twisted: Well I said it should be 22..... Now that doesn't mean I haven't play in way deeper stuff
If you are going to make a claim like that ... you know the rules ... PICS OR IT DIDN'T HAPPEN |
|
| Author: | Diggerfreek [ Wed Aug 19, 2009 10:41 pm ] |
| Post subject: | |
Note... All water crossing will be judged on how @$#% up your front plate is
|
|
| Author: | Mike08Liberty [ Wed Aug 19, 2009 11:34 pm ] |
| Post subject: | |
Diggerfreek wrote: :twisted: Do videos count?
Eh, I gess that'll do |
|
| Author: | Jonny5 [ Thu Aug 20, 2009 7:48 pm ] |
| Post subject: | |
I think I should of taken this a bit slower... But then again only issue was the front plate.
|
|
| Author: | Diggerfreek [ Thu Aug 20, 2009 7:51 pm ] |
| Post subject: | |
|
|
| Author: | 1quick1 [ Fri Aug 21, 2009 9:44 pm ] |
| Post subject: | |
I don't think it's in the manual. I'm almost positive I read it going through all the options on Jeep's site but the KK they say is 21'' |
|
| Author: | nightdrv [ Sat Aug 22, 2009 3:13 pm ] |
| Post subject: | |
A certain person on here told me 20". I won't name names because of his ego. I myself have only been into 19". |
|
| Author: | Diggerfreek [ Sat Aug 22, 2009 6:25 pm ] |
| Post subject: | |
Flowing Water If the water is swift flowing and rising (as in storm run-off) avoid crossing until the water level recedes and/or the flow rate is reduced. If you must cross flowing-water, avoid depths in excess of 9 inches. The flowing water can erode the streambed causing your vehicle to sink into deeper water. Determine exit point(s) that are downstream of your entry point to allow for drifting. Standing Water Avoid driving in standing water deeper than 20 inches, and reduce speed appropriately to minimize wave effects. Maximum speed in 20 inches of water is less than 5 mph (8 km/h). |
|
| Author: | GREEKJEEPER [ Sun Aug 23, 2009 2:15 am ] |
| Post subject: | |
Diggerfreek wrote: :
Note... All water crossing will be judged on how @$#% up your front plate is I did a pass like that (in a river) and lost my plate. Now , after i pay 70eyro for a new one , i have 4 bolts to secure it. |
|
| Author: | BrendonR [ Sun Aug 23, 2009 10:22 am ] |
| Post subject: | |
Diggerfreek wrote: Flowing Water
If the water is swift flowing and rising (as in storm run-off) avoid crossing until the water level recedes and/or the flow rate is reduced. If you must cross flowing-water, avoid depths in excess of 9 inches. The flowing water can erode the streambed causing your vehicle to sink into deeper water. Determine exit point(s) that are downstream of your entry point to allow for drifting. Standing Water Avoid driving in standing water deeper than 20 inches, and reduce speed appropriately to minimize wave effects. Maximum speed in 20 inches of water is less than 5 mph (8 km/h). Now that certainly sounds official - where'd this come from Digger? |
|
| Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|