| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| 2008 liberty lift http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=58632 |
Page 1 of 1 |
| Author: | bobandcar [ Sun Jan 30, 2011 7:28 pm ] |
| Post subject: | 2008 liberty lift |
we have a 08 liberty sport 4x4. i don't know much about this trucks suspension. i did lift my pickup with coil spacers in the front and an add a leaf in the rear and i am mechanicly inclined. what are the smaller lifts out there and there respective costs. i am looking for enough to go up a tire size or 2 for additional ground clearence |
|
| Author: | FDez [ Sun Jan 30, 2011 7:36 pm ] |
| Post subject: | Re: 2008 liberty lift |
There are a couple for the KK. Everyone here is going to tell you that the JBA lift is difinitely the best but it is also the most expensive. $980 for the base 2". The Rocl Krawler is what I have. It ia a clevis lift. 3.5" lift (more like 3") and more reasonable cost. $300 Then there are the spacer lifts, daystar, etc. which are even less. There is a thread in the tech section that has all of the avaialble lifts and manufacturers etc. If you do a search you will find many threads on the subject. Good luck. This is what the Rock Krawler will give you.
|
|
| Author: | RedRock08 [ Thu Feb 03, 2011 9:44 pm ] |
| Post subject: | Re: 2008 liberty lift |
bobandcar wrote: we have a 08 liberty sport 4x4. i don't know much about this trucks suspension. i did lift my pickup with coil spacers in the front and an add a leaf in the rear and i am mechanicly inclined. what are the smaller lifts out there and there respective costs. i am looking for enough to go up a tire size or 2 for additional ground clearence 2 Daystar lift $165 265/60 18 Nito Terra Grapplers $ too much 1/2 inch Wheel Spacers
|
|
| Author: | das4x4 [ Thu Feb 03, 2011 10:45 pm ] |
| Post subject: | Re: 2008 liberty lift |
I ran the 2" Daystar spacer lift for awhile and really liked the look it gave. I saved and switched to the JBA 2.5 for the stronger suspension components over stock. Rockfather 3.5" seems easiest to install, good lift amount, and easiest to return to stock if needed. JBA 4" isn't cheap and has some more mods to make, but components were designed for the Libby specifically. JBA also has high customer satisfaction. Good luck in your quest. Lots of knowledgable people on here so ask lots of questions if you can't find it in past threads. Here is my 08 Red Rock with the jba 2.5 Happy ![]() [
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|