| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Top plate stud size? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=63216 |
Page 1 of 1 |
| Author: | At The Helm [ Mon Oct 17, 2011 2:37 pm ] |
| Post subject: | Top plate stud size? |
Anyone know what size studs are used for the spring/shock assembly top plate? After pressing in/out a couple of times trying stock top plate vs daystar the knurled part is smooth now so i need to replace because one of them won't tighten now. Thanks |
|
| Author: | tommudd [ Mon Oct 17, 2011 3:37 pm ] |
| Post subject: | Re: Top plate stud size? |
On KJs a Ford Taurus wheel stud would work not sure on the KKs but worth a shot |
|
| Author: | At The Helm [ Mon Oct 17, 2011 5:00 pm ] |
| Post subject: | Re: Top plate stud size? |
Thanks Tom, i know the kk ones look different and might be a little bit longer. They have pointed ends and also have enough threads to run a 3/8" plate along with the daystar plate. I could even run a 10.9 bolt because lucky for me its the only one not partially covered by the top isolator, so i can get in there with a wrench and not have disassemble the susp again. So i guess the real question is: what diameter, length and thread pitch are they? I only have an sae gauge and 29/64ths was the closest. Probably just have to remove it and go to napa. |
|
| Author: | At The Helm [ Thu Oct 20, 2011 12:51 pm ] |
| Post subject: | Re: Top plate stud size? |
For search reference purposes: it is def m12x1.75 Pretty sure 36mm length and knurl diameter of 13.9. Good luck finding these. I'm just going to tack weld them in so they won't spin. Napa part # 641-1622 will work but you have bore out the holes because of the larger knurl diameter and also buy new nuts because they are m12x1.5 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|