| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| 265-70-16 plus daystar lift http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=63577 |
Page 1 of 1 |
| Author: | smigelskijk [ Tue Nov 08, 2011 8:27 am ] |
| Post subject: | 265-70-16 plus daystar lift |
Will the 265-70-16 work with daystar lift could I push it to 265-75-16? I see most daystar lifts get 245-75-16 good. Just trying to way out tire options. Thanks for any input. O yea I will also have boiler shims up front! And 4 ISOs in the back. Ok think that's it 
|
|
| Author: | tommudd [ Tue Nov 08, 2011 10:45 am ] |
| Post subject: | Re: 265-70-16 plus daystar lift |
Depending on tire brand, 265-70s maybe too wide and rub more. Even though they are pretty much the same height as 245-75s the extra width will get you. 265-75s NO! Besides being too tall, they will fit sitting still wheels pointing straight ahead but driving / turning there would be rub ( know for a fact since we've tried it in my driveway) ALSO you would need to regear to at least 4.10s |
|
| Author: | smigelskijk [ Tue Nov 08, 2011 11:07 am ] |
| Post subject: | Re: 265-70-16 plus daystar lift |
So 245-75-16s it is thanks for the info! |
|
| Author: | smigelskijk [ Wed Nov 09, 2011 10:01 pm ] |
| Post subject: | Re: 265-70-16 plus daystar lift |
what if i had the boiler shim in front and 2 iso in the rear on each side, then maybe i could get 245-75s on there? also how many iso is two many on each side? |
|
| Author: | infernicus [ Thu Nov 10, 2011 1:13 am ] |
| Post subject: | Re: 265-70-16 plus daystar lift |
smigelskijk wrote: what if i had the boiler shim in front and 2 iso in the rear on each side, then maybe i could get 245-75s on there? also how many iso is two many on each side? Maximum is three (3) total each side. One factory original. Two extras. |
|
| Author: | tommudd [ Thu Nov 10, 2011 8:42 am ] |
| Post subject: | Re: 265-70-16 plus daystar lift |
smigelskijk wrote: what if i had the boiler shim in front and 2 iso in the rear on each side, then maybe i could get 245-75s on there? also how many iso is two many on each side? No, front top plates from Boiler will only raise it an extra 3/4 of an inch not enough to run 254-75s by them selves You have to have a lift to run 245-75s or anything taller than stock Do it right the first time or don't do it at all 
|
|
| Author: | smigelskijk [ Thu Nov 10, 2011 8:43 am ] |
| Post subject: | Re: 265-70-16 plus daystar lift |
So with that set up will the 245-75s fit on? Also going to have the shims up front |
|
| Author: | smigelskijk [ Thu Nov 10, 2011 9:02 am ] |
| Post subject: | Re: 265-70-16 plus daystar lift |
Thanks for all the help. Sure glad I found this forum that contains all this knowledge. Sure would have messed some things up thanks guys and gals. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|