| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| side moldings and mud guard questions http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=65559 |
Page 1 of 1 |
| Author: | KEB [ Wed Feb 29, 2012 10:02 pm ] |
| Post subject: | side moldings and mud guard questions |
Has anyone else noticed that the rear end catches everything that you drive through? It gets So dusty So fast. I've also noticed it on some Commanders in my area. I don't even live in a dusty region, NW Ohio. Would mud guards help with this problem? I don't want to spend the $40-$50 on them if they don't work. I am also getting ready for my next project and need to know how to get those side moldings off? The black ones that say Liberty (silver on limited models) I'm either going to paint them the body color, red, or silver like the limited. Cheaper then buying them that's for sure! thanks for the help! |
|
| Author: | Diggerfreek [ Thu Mar 01, 2012 9:39 am ] |
| Post subject: | Re: side moldings and mud guard questions |
KEB wrote: Has anyone else noticed that the rear end catches everything that you drive through? It gets So dusty So fast. I've also noticed it on some Commanders in my area. I don't even live in a dusty region, NW Ohio. Would mud guards help with this problem? I don't want to spend the $40-$50 on them if they don't work. I am also getting ready for my next project and need to know how to get those side moldings off? The black ones that say Liberty (silver on limited models) I'm either going to paint them the body color, red, or silver like the limited. Cheaper then buying them that's for sure! thanks for the help! They are held on with double sided tape. Sorry I can't help with the mud flap question... |
|
| Author: | Mike08Liberty [ Thu Mar 01, 2012 10:25 am ] |
| Post subject: | Re: side moldings and mud guard questions |
As digger said they are held on with double sided tape but if you pull to hard you will break them (I know from experience  )What you want to do it start at the door edge and pull it back gently while at the same time taking a sharp plastic putty knife and cut the tape. If you pull and cut the tape at the same time you can get it worked off without breaking it. |
|
| Author: | black and blue [ Thu Mar 01, 2012 8:45 pm ] |
| Post subject: | Re: side moldings and mud guard questions |
i noticed this recently as i found the relay for my new back-up lights had one wire already corrode and come unconnected gotta find a better place for it now |
|
| Author: | musclezmarinara [ Fri Mar 02, 2012 12:05 am ] |
| Post subject: | Re: side moldings and mud guard questions |
Use a heat gun also! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|