The guy that owned the jeep before me put on these plastic wheel covers that are supposed to make the rims look chrome. I want to remove them but I'm not exactly sure where to start with this. It looks like they just snap right on to the factory rim but I'm not gonna risk damaging something without knowing for sure. Here's a link to the product if it's any helpful.

http://www.amazon.com/2008-2012-Liberty ... B004BU8YGC

Any help is appreciated.
Thanks

_________________
2011 Black KK

they should just snap in... thats all i can figure with a little research i did on it... kinda like a hub cap

_________________
'06 KJ SPORT 3.7L

I had the same on mine when I bought it. There's tabs on the back of the wheelskin that hold it on to each spoke. Just stick a wrench in the back so it presses on both tabs on the spoke and pull forward. It will pop right off. Repeat for each spoke.

_________________
2008 Jeep Liberty KK, SkySlider, Tow Package, OME/Bilstein Lift, Flowmaster Delta 50, Removed Resonator, DuraTracs, In-dash CB, PIAA 520 ATPs, Dual KJ Tow Hooks
http://www.cardomain.com/ride/3974106/2008-jeep-liberty
Lost Jeeps PNW/BC Members Map

yep, just pull that crap off and throw them in the garbage...that's what I did