| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Skid plate bolt size? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=66827 |
Page 1 of 1 |
| Author: | At The Helm [ Thu May 10, 2012 12:31 am ] |
| Post subject: | Skid plate bolt size? |
Does anyone know the size of the bolt that is used on the front of the trans skid and the rear of the engine skid? I am not talking about the nutserts that you would install yourself. They are already there and located on the foreward crossmember under the oil pan. |
|
| Author: | At The Helm [ Thu May 10, 2012 12:40 am ] |
| Post subject: | Re: Skid plate bolt size? |
Nevermind found it. M10x1.5x35.00 |
|
| Author: | musclezmarinara [ Thu May 10, 2012 2:18 pm ] |
| Post subject: | Re: Skid plate bolt size? |
10 x 1 yuup |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|