LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Help removing blinker housings
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=69854		 Page 1 of 1
Author:  TIJKK1220 [ Sun Aug 05, 2012 6:56 pm ]
Post subject:  Help removing blinker housings
Just cracked open my headlights and want to paint my blinkers as well but can not figure out how they are removed.

I don't really want to remove my whole bumper just to find out there are like 2 clips or something that need to be undone

anyone have a diagram or prior experience taking them off?
Author:  At The Helm [ Sun Aug 05, 2012 8:24 pm ]
Post subject:  Re: Help removing blinker housings
I've only removed them with the bumper off, but i think it can be done with it on. There is a bolt on the back side under the liner and a metal clip holding the signal in. If you can get ahold of it it should come off by pulling foreward after removing the bolt and wire harness.
Author:  TIJKK1220 [ Sun Aug 05, 2012 8:26 pm ]
Post subject:  Re: Help removing blinker housings
Atthehelm wrote:
I've only removed them with the bumper off, but i think it can be done with it on. There is a bolt on the back side under the liner and a metal clip holding it in. If you can get ahold of it it should come off by pulling foreward after removing the bolt and wire harness.



Awesome! I saw the bolt and actually moved the liner to get a better look I thought it was some sort of leveler or something along those lines. what size is the bolt?

Thanks So much for the info!

EDIT: Thanks to your help and another quick scan of google i found diggers thread a while back where some one had asked the same question. I feel silly for not searching harder and thanks again!
Author:  At The Helm [ Sun Aug 05, 2012 11:44 pm ]
Post subject:  Re: Help removing blinker housings
Its a 10 or 12mm. You're gonna have to pull pretty hard to release that clip.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/