After JBA 2.5 lift, slight vibration on excelaration

At The Helm · **Posted:** Tue Oct 23, 2012 11:22 am

Good job Lowgunner. Personally I would have put the tire and can holder a lot higher, but if your carrier suits your needs then power to ya. Good idea with the forklift burn table btw.

tjkj2002 · **Posted:** Tue Oct 23, 2012 12:11 pm

Yeah that spare is sitting mighty low.

Mine sits really high and is a 35" tire and I barely notice it.Takes like 20 seconds to open both swing outs to access the rear.

And from this angle you can see the spare is also at a angle,same angle as the rear glass for even more clearance.

lowgunner · **Posted:** Tue Oct 23, 2012 3:40 pm

Thanks Atthehelm,

however, it's my friend's burn table; the guy has been welding for over 30+ yrs and was willing to help with this project. I think he may be sick of me after this one is finished :banghead:

After JBA 2.5 lift, slight vibration on excelaration

Who is online