LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
Anybody have JBA 2.5" rear lift springs? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=75155 |
Page 1 of 1 |
Author: | DirtyKK [ Sat May 04, 2013 1:54 pm ] |
Post subject: | Anybody have JBA 2.5" rear lift springs? |
Im looking for height measured from center of wheel to bottom of flare if you do. im looking for straight coil lift not additional spring isolators stacked for more lift, unless theyre used to level from side to side. thanks in advance for your help. |
Author: | Scar0 [ Mon May 06, 2013 4:10 am ] |
Post subject: | Re: Anybody have JBA 2.5" rear lift springs? |
I have them on my ride, but my measurements will be slightly different then yours. What is it you are trying to figure out, sagging? I can get them tomorrow if you like. It's been a while since I measured mine. Being the prototype for the KA I had two different sets on it. The first set (middle) only produced about 1.75" lift. The second set on the left is what I have now. On the right is stock. ![]() |
Author: | DirtyKK [ Mon May 06, 2013 5:12 am ] |
Post subject: | Re: Anybody have JBA 2.5" rear lift springs? |
Right now Im sitting at 22.5" all around and I would like to take 1-1.5" off. |
Author: | Scar0 [ Mon May 06, 2013 9:33 pm ] |
Post subject: | Re: Anybody have JBA 2.5" rear lift springs? |
Ah, gotcha. I see you have a reply in the other thread, so no need for me to go out and check. |
Author: | _benjammin [ Tue May 07, 2013 12:35 pm ] |
Post subject: | Re: Anybody have JBA 2.5" rear lift springs? |
I'm at 21.5 with just the JBA springs and bilstein shocks. |
Author: | DirtyKK [ Tue May 07, 2013 8:54 pm ] |
Post subject: | Re: Anybody have JBA 2.5" rear lift springs? |
_benjammin wrote: I'm at 21.5 with just the JBA springs and bilstein shocks. Thanks that exactly what Im looking for. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |