LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Red Circle Dash Light
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=75647		 Page 1 of 1
Author:  Gageraid [ Wed Jun 19, 2013 12:07 am ]
Post subject:  Red Circle Dash Light
I've done some searching and it seems like it might be the alarm light???

Here's the situation. BEFORE it got lifted when driving on the highway that red dot lit up WITH the tire pressure light, too. This has happened on two different occasions. A third time, AFTER the OME lift, it happened when I was going 25 mph, but I don't recall the tire pressure light coming on with it this time.

I have not been able to make this happen on command, but need to know if it's a safety issue. Thanks for any suggestions and/or answers.
Author:  Gageraid [ Wed Jun 19, 2013 11:00 pm ]
Post subject:  Re: Red Circle Dash Light
Bump... Jeep Gods?
Author:  Gageraid [ Mon Dec 09, 2013 11:58 am ]
Post subject:  Re: Red Circle Dash Light
When I went skiing the other day, about an hour into driving this happened again. Didn't notice any change in performance.
I'm guessing it's a bad sensor somewhere in one of the wheels.
Author:  ajohns1288 [ Mon Dec 09, 2013 9:52 pm ]
Post subject:  Re: Red Circle Dash Light
I think its the light for the security system. The common factor between the tire pressure light and that light is that both signals run through the wireless control module that sits on the side of the steering column. That module reads the TPM signals as well as remote start and sentry key signals. If there is anything wrong, it should set a code, but you can't read it with a normal OBDII scanner. You'll need either a dealer tool or another reader that you can send CAN commands with. If you have one, let me know and I can give you a quick rundown on how to scan the other modules for any codes.
Author:  Gageraid [ Mon Dec 09, 2013 10:34 pm ]
Post subject:  Re: Red Circle Dash Light
ajohns1288 wrote:
I think its the light for the security system. The common factor between the tire pressure light and that light is that both signals run through the wireless control module that sits on the side of the steering column. That module reads the TPM signals as well as remote start and sentry key signals. If there is anything wrong, it should set a code, but you can't read it with a normal OBDII scanner. You'll need either a dealer tool or another reader that you can send CAN commands with. If you have one, let me know and I can give you a quick rundown on how to scan the other modules for any codes.


Thanks for the reply!
All I have is a ScanGauge...
Honestly, I wouldn't know if this KK even has a security system, because I've never set it off before.
Author:  Mikzor [ Tue Dec 10, 2013 1:32 am ]
Post subject:  Re: Red Circle Dash Light
Gageraid wrote:
Honestly, I wouldn't know if this KK even has a security system, because I've never set it off before.


Wind your windows down, lock the car then manually reach in and pull the door lock up. That's how I set my alarm off... didn't even know I had one till that day.
Author:  Gageraid [ Tue Dec 10, 2013 10:49 am ]
Post subject:  Re: Red Circle Dash Light
Mikzor wrote:
Gageraid wrote:
Honestly, I wouldn't know if this KK even has a security system, because I've never set it off before.


Wind your windows down, lock the car then manually reach in and pull the door lock up. That's how I set my alarm off... didn't even know I had one till that day.


Good idea! I guess it would also work if I hit the panic button.
Author:  Bmxer524 [ Tue Dec 10, 2013 1:52 pm ]
Post subject:  Re: Red Circle Dash Light
I don't have an alarm, but have the panic button that works. Just use the window method.
Author:  Gageraid [ Tue Dec 10, 2013 5:35 pm ]
Post subject:  Re: Red Circle Dash Light
I can't get the alarm to work... only the panic button works.
:?
Author:  huntb [ Tue Dec 10, 2013 5:41 pm ]
Post subject:  Re: Red Circle Dash Light
Do you have a spare key? I think this red light comes on when the vehicle can't sense the RFID chip in the key
Author:  Gageraid [ Tue Dec 10, 2013 5:45 pm ]
Post subject:  Re: Red Circle Dash Light
huntb wrote:
Do you have a spare key? I think this red light comes on when the vehicle can't sense the RFID chip in the key


I do have a spare.
I haven't had this problem happen in a while and I can't duplicate it.
Maybe next time I go skiing it will illuminate again during the hour drive.
I would be able to understand if it was just the tire pressure warning light, but why would it be a combination of both?
Author:  ajohns1288 [ Tue Dec 10, 2013 10:20 pm ]
Post subject:  Re: Red Circle Dash Light
Gageraid wrote:
ajohns1288 wrote:
I think its the light for the security system. The common factor between the tire pressure light and that light is that both signals run through the wireless control module that sits on the side of the steering column. That module reads the TPM signals as well as remote start and sentry key signals. If there is anything wrong, it should set a code, but you can't read it with a normal OBDII scanner. You'll need either a dealer tool or another reader that you can send CAN commands with. If you have one, let me know and I can give you a quick rundown on how to scan the other modules for any codes.


Thanks for the reply!
All I have is a ScanGauge...
Honestly, I wouldn't know if this KK even has a security system, because I've never set it off before.


If you have a ScanGauge with the X-Gauge feature, you should be able to use it to get codes from all the other modules on the CAN bus. You'll set the TXD to 0XXX1800FF00, where XXX is the address of the specific module you want codes from. I'm not sure what RX and MAT stuff should be set at, but I'll take a look to see how the system works. If I can figure it out, I'll let you know what the settings should be.
Author:  Gageraid [ Tue Dec 10, 2013 10:45 pm ]
Post subject:  Re: Red Circle Dash Light
ajohns1288 wrote:
Gageraid wrote:
ajohns1288 wrote:
I think its the light for the security system. The common factor between the tire pressure light and that light is that both signals run through the wireless control module that sits on the side of the steering column. That module reads the TPM signals as well as remote start and sentry key signals. If there is anything wrong, it should set a code, but you can't read it with a normal OBDII scanner. You'll need either a dealer tool or another reader that you can send CAN commands with. If you have one, let me know and I can give you a quick rundown on how to scan the other modules for any codes.


Thanks for the reply!
All I have is a ScanGauge...
Honestly, I wouldn't know if this KK even has a security system, because I've never set it off before.



If you have a ScanGauge with the X-Gauge feature, you should be able to use it to get codes from all the other modules on the CAN bus. You'll set the TXD to 0XXX1800FF00, where XXX is the address of the specific module you want codes from. I'm not sure what RX and MAT stuff should be set at, but I'll take a look to see how the system works. If I can figure it out, I'll let you know what the settings should be.

Yes I have a ScanGauge2 that has the x-gauge feature. This will be able to help me out with my issue? You lost me there with all that information.
Author:  huntb [ Tue Dec 10, 2013 11:54 pm ]
Post subject:  Re: Red Circle Dash Light
Gageraid wrote:
huntb wrote:
Do you have a spare key? I think this red light comes on when the vehicle can't sense the RFID chip in the key


I do have a spare.
I haven't had this problem happen in a while and I can't duplicate it.
Maybe next time I go skiing it will illuminate again during the hour drive.
I would be able to understand if it was just the tire pressure warning light, but why would it be a combination of both?


It has nothing to do with the TPMS light. Purely coincidence
Author:  Gageraid [ Wed Dec 11, 2013 8:31 am ]
Post subject:  Re: Red Circle Dash Light
Okay, thanks. Anything I should maybe take notice of if it ever happens again?
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/