Today while driving I had my tire pressure light start flashing. So I pulled over and checked all of my tires and they were fine. I shut it off and restarted it and its still on. It will alternate between flashing and solid. Any of y'all have any ideas? I'm thinking it could be one of the sensors out.

_________________
(The worst thing you can do to a Jeep...is never taking it off road.)
'15 WK2 Ecodiesel Overland (My Overland rig)
'11 Green KK Renegade (My Crawler!)
Texans, come join us at Lone Star LOST!
https://www.facebook.com/groups/253493118163702?ref=bookmark&_rdr

Wait till tomorrow morning to check them while they are completely cold.
Fill them up after that.
The light still might be on for a few miles. When I had a nail in my tire removed, the light stayed on for a few miles and eventually went off.
Might be the sensor though.

EDIT: Do you have an EVIC to show which tire it is saying is low?

_________________
2008 Black Jeep Liberty Sport
4.7L throttle body
Old Man Emu lift
Sky Slider
Hypertech Max Energy
K&N CAI
Gibson stainless steel exhaust
Blacked out
ScanGauge2
BFG All Terrrain 225/75/16
JBA upper control arms

The flashing means there is a system fault, nothing to do with air pressure. It will flash for 70sec then stay solid until the next key cycle. Mine does this every once in a while, then goes away. Supposedly radio interference can cause it. If it is staying around, it is probably a bad sensor (~$50) or a bad WCM (~$200). If you have a ELM327 or similar OBD reader, you can send a command and have it report the DTCs, otherwise, you are stuck going to someone with the dealer tool.

_________________
2008 Liberty Sport
OME Lift, JBA A-Arms + Track Bar
245/75/16 Nokian Rotiiva AT Plus
Numerous junkyard upgrades