Check connectors behind the control pannel
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Heater controls not working http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=78162 |
Page 1 of 1 |
| Author: | 99sportcummins [ Wed Jan 29, 2014 5:46 pm ] |
| Post subject: | Heater controls not working |
On my moms 2010 liberty the heater controls quit working. The only good thing is that the blower is stuck on high and heat. I know on my truck it is vacuum controlled but I assume it is electrical on the liberty. Just wondering what could cause those before I go look at it |
|
| Author: | khalilw [ Wed Jan 29, 2014 6:34 pm ] |
| Post subject: | Re: Heater controls not working |
Check connectors behind the control pannel
|
|
| Author: | lfhoward [ Wed Jan 29, 2014 9:18 pm ] |
| Post subject: | Re: Heater controls not working |
If the fan will only blow on high, you might try swapping out your blower motor resistor behind the glove box. If the temperature adjustment is also not working, it's probably something more like what Khalilw suggested. |
|
| Author: | Scar0 [ Wed Jan 29, 2014 9:38 pm ] |
| Post subject: | Re: Heater controls not working |
lfhoward wrote: If the fan will only blow on high, you might try swapping out your blower motor resistor behind the glove box. If the temperature adjustment is also not working, it's probably something more like what Khalilw suggested. I'll second the resister. But there may be an underlying issue if the resister burnt up. Could be the blower motor is drawing too much current because it is starting to wear out. Just something to keep in mind... |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|