Has anyone here replaced the interior lights with LEDs?

ajohns1288 · **Posted:** Sat Aug 17, 2013 8:33 am

I'm looking into replacing the courtesy/dome lamps with LEDs. Does anyone have any tips/warnings or suggestions of where to buy from?

At The Helm · **Posted:** Sat Aug 17, 2013 11:04 am

I'm running cheap ebay leds on all my interior bulbs, only one of the sets came doa but the seller sent new ones.
Use the sylvania osram bulb guide to find the bulb numbers.

lammarco · **Joined:** Sun Mar 18, 2012 3:37 pm **Posts:** 274

Just make sure the LED is made for CAN bus...otherwise they won't turn on or will/might get error codes... If done right, it will looks awesome! :grim:

12KK SFD · **Posted:** Mon Aug 19, 2013 11:22 am

I did a full LED interior conversion on my previous vehicle. I'm not sure I'd do it again as it was pretty bright. But, it did look nice when I unlocked my doors and my LED license plate lights and puddle lights illuminated with the interior lights.

nFodzy · **Joined:** Sun Oct 06, 2013 1:30 pm **Posts:** 389

Anyone ever find the bulbs needed for all the interior lights? I went on the Osram Sylvania light guide and the codes don't come up. Just looking for cheap LED lights to replace the dull stock ones.

Fishnalaska · **Posted:** Sun May 25, 2014 10:57 pm

The map lights and back cargo lights are a 44mm festoon bulb according to the chart, but I thought they were a little long, the ones I ordered fit, but were tight. The footwell and grab handle lights for the rear passenger were just a 168/194 wedge base bulb.

Has anyone here replaced the interior lights with LEDs?

Who is online