hello all, I own a 2007 KA Dodge nitro and im lifted 2.5" in the front and 4" in the rear running 265/70r17. i just finished my steel bumper for it and now it sags in the front due to the weight. i found on jeepin by al a 1" clevis strut spacer and was wondering if anyone knew if when i add the spacer if it will stress/damage anything on the front end. Thanks! -Obee

1" is a huge spacer for a clevis lift. I wouldn't do anything over 1/2" spacer, and even that is pushing it(for safety reasons).

All the spacer does is act as a measuring device when you slide the clevis down the shock. Most do 3/8", some do 1/2". Everything in front doubles, so that 1/2" becomes an inch of lift.

What lift do you have now? You shouldn't have any problems after install unless it puts you over 3" of lift. After 3" you start to need a-arms to help with contacting the springs.

_________________
2011 Deep Cherry Red KK - Skyslider - JBA/Bilstein Adjust-A-Strut set at 3.5" - OME 731 Rear Springs - Bilstein Rear Shocks - Al's A-arms - 245/75-16 Duratracs - Rock Liazard Super Sliders

First. what lift do you currently have and have you already added a clevis lift or top plate?
Next 2.5 front and 4 inch rear Why?
Biggest clevis spacer you can use is .500 depending on what you already have , and what setup.

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

NEED PICS of ATH bumper center section installed! How did you modify it for the KA's lower sitting radiator?

_________________
07 KA Light Khaki, Manual trany.
2.5" Adjust-A-Strut JBA lift, Euro taillights,
Home made; Front Tilt Hood, Roof Rack, RAM Air, & CAI.
ESP Off Switch
Take a ride on the Trō side!