LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Fill & Drain Plug Socket Size - Front Differential
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=81349		 Page 1 of 1
Author:  baseballflash5 [ Fri Feb 13, 2015 5:24 pm ]
Post subject:  Fill & Drain Plug Socket Size - Front Differential
Hi everyone,

Changing the front differential oil on my 2012 KK, and trying to figure out what size square socket to get for the fill plug and what sixe hex socket to get for the drain plug. Measuring the plugs with a ruler, it seems like the sockets should be both around 8mm in size. Does anyone know if this is correct? If not, what size?
Author:  Erikg84 [ Fri Feb 13, 2015 5:50 pm ]
Post subject:  Re: Fill & Drain Plug Socket Size - Front Differential
Just use a 3/8" Drive socket extension for the drain plug... No need to use any sockets.

edit: I just noticed that you also need the fill plug size. I know it's an allen key, but I forget what size.
Author:  baseballflash5 [ Fri Feb 13, 2015 5:54 pm ]
Post subject:  Re: Fill & Drain Plug Socket Size - Front Differential
Erikg84 wrote:
Just use a 3/8" Drive socket extension for the drain plug... No need to use any sockets.

edit: I just noticed that you also need the fill plug size. I know it's an allen key, but I forget what size.


Thanks. What about the hex socket for the drain plug?
Author:  NAMoulton1 [ Fri Feb 13, 2015 9:56 pm ]
Post subject:  Re: Fill & Drain Plug Socket Size - Front Differential
baseballflash5 wrote:
Erikg84 wrote:
Just use a 3/8" Drive socket extension for the drain plug... No need to use any sockets.

edit: I just noticed that you also need the fill plug size. I know it's an allen key, but I forget what size.


Thanks. What about the hex socket for the drain plug?


Not a socket, use an allen key...somewhere around a 1/4" ish
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/