First, to the moderators, I believe this is not the correct place for the post, but i am not sure where it should go, so I am sorry for that.
So I made my own Bumper
And I have enough left over parts to make another 2. These are all CNC Laser cut to the model. And they come together like a puzzle (I use slots and tabs to fit it all together at the correct angles and distances some tabs require some deburing so it will slide in) The center section will receive a winch and it is made of 1/4 inch thick steel all around. The wings are made of 1/8 steel. And they bolt to the center section. No drilling required, it mounts to the same holes as the tow hooks. I am asking for 250 dollars, plus delivery.
There is one catch. It is not welded. I will be sending you the laser plates (some of them are CNC pressed you won't have to bend them) with instructions and drawings/prints how to assemble it, and no hardware, but all the hardware is either M10 or M8 you can get it all from McMaster carr cheap.
And don't worry it does come with a bracket for the turn signal (which honestly I am pretty darn proud of it and how well it turnout!) And the side marker also mounts to the bumper. I kind of got inspired by Mt. Luvrn bumper, but with my own twist to it.
If you are interested please PM me.