| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Replaced Water Pump, Jeep Doesn't Start http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=86276 |
Page 1 of 1 |
| Author: | bangschr [ Tue Mar 14, 2017 9:33 pm ] |
| Post subject: | Replaced Water Pump, Jeep Doesn't Start |
Ok, hopefully someone has a solution. I replaced my water pump today on my 2008 Jeep Liberty, but had to remove the alternator to have enough room to get the old pump out. I disconnected the negative terminal during this. After finishing, I try to start the Jeep...but nothing. I have no power anywhere except for the dome light. I also cannot get the car out of park. I tried to jump off the car, but that didn't help. I did notice that if I disconnect both terminals for a few minutes then reconnect...the horn beeps. But then I'm back to the same situation. Any ideas? Could it be something to do with the key fob? That stopped working about 6 months ago, and didn't cause any problems then. |
|
| Author: | lfhoward [ Wed Mar 15, 2017 11:22 am ] |
| Post subject: | Re: Replaced Water Pump, Jeep Doesn't Start |
Check the ground strap & other electrical connections from the alternator to the battery / TIPM (black fuse box under the hood). Getting nothing at all sounds like a main circuit is not being completed. |
|
| Author: | bangschr [ Wed Mar 15, 2017 2:30 pm ] |
| Post subject: | Re: Replaced Water Pump, Jeep Doesn't Start |
I'll try that. I believe it has something to do with the IOD fuse. If I pull the fuse, all power comes back on but the horn and wipers go nuts. |
|
| Author: | Scar0 [ Wed Mar 15, 2017 9:16 pm ] |
| Post subject: | Re: Replaced Water Pump, Jeep Doesn't Start |
IOD= Ignition Off Draw. With that out nothing ignition related should work. You should also get a "NO FUSE" message in your cluster with it out. Sorry to say, but I think you have a major short in the TIPM. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|