| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Grinding noise when selecting reverse gear http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=86298 |
Page 1 of 1 |
| Author: | nkanakakis [ Sat Mar 18, 2017 5:32 pm ] |
| Post subject: | Grinding noise when selecting reverse gear |
Today I discovered that when I shift out off 4wd low and then select the reverse gear my 2008 liberty kk makes a loud grinding noise I have to shift back to neutral in order to stop the noise After that everything works like a charm No check engine light and all the above never happens again until I repeat the same procedure (shifting out from 4wd low and put the tranny to reverse) Any ideas ??? |
|
| Author: | ajohns1288 [ Sat Mar 18, 2017 6:42 pm ] |
| Post subject: | Re: Grinding noise when selecting reverse gear |
I've had that happen a few times too, do you have a tune installed? It sounds to me like I shifted into reverse before the tcase finished shifting. I think it was the clutches in the trans slipping, but I threw it back into neutral before I could tell where it was coming from. |
|
| Author: | nkanakakis [ Sat Mar 18, 2017 7:31 pm ] |
| Post subject: | Re: Grinding noise when selecting reverse gear |
No tune installed You think a tune can fix the problem ? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|