Hey everyone it's been a long while since I have posted. I need some guidance here. So this is the deal. I started out with this OME install about a month ago. I installed the front spring and shocks with no real issues aside from popping noises, I think I need to turn the spring so it sits flush on the rubber stopper. 2 weeks later I installed the rear... While removing the upper driver side sway bar link I snapped the bold off with half still in. So after hours of different extractors to no avail I had to drill out the whole thing. This caused the loss of the nut welded to the inner frame. I decided to drill a whole all the way through the frame and install a much longer bolt..........its not over yet. After looking everywhere open at the time the closest bolt I could find was 3/8 (a little small). I bolted the thing up; it wasnt pretty and it wasnt super straight but it was tight. With this known here are my symptoms.
At low speeds(below 25ish) I have a semi constant up and down bounce. This is not a swooping swaying bounce as in shocks. its like a slight boing boing boing but bouncy you know. I feel like a beer keg being shook up. I had the alignment and its as good as it can get i think it was 1 deg off on each side.
Does anyone thing removing the rear sway bar all together might help? I can shake the jeep side to side in the rear and when i stop it stops.....weird.
Any and all suggestions appreciated