Hi, It runs fine when started, gave a good run, then switched of would not restart?
Possible fuel pressure? crank engine lot of fuel to injectors but have no pressure gauge to test pressure. Manually pumped filter housing (screw in plunger type) seams to operate ok.
With ign on, No live to crank sensor. Its a two wire with a braided earth? rev counter does not register anything when cranking. I have fit a new crank sensor and map sensor.
Cam sensor has a 12v feed to it and pulses when cranks.
I have no scanner or pressure gauge. I live in the middle of France, the garages around here just try sensors one by one ?
Can anybody help?

Since it is a CRD you should post your question in the CRD (diesel section).
Follow this link.
viewforum.php?f=5

_________________
07 KA Light Khaki, Manual trany.
2.5" Adjust-A-Strut JBA lift, Euro taillights,
Home made; Front Tilt Hood, Roof Rack, RAM Air, & CAI.
ESP Off Switch
Take a ride on the Trō side!