There isn't a good way to replace those without removing the light housings from the front of the Jeep first.
1. Pop the hood. Move the hood latch cable out of the way.
2. Remove 8 black plastic inserts from the top of the grill housing.
3. Unscrew and remove 2 rubber hexagonal hood bumpers.
4. Unclip grill at upper outside corners.
5. Using a flat small screwdriver, unclip grill inside the gap between the grill and the turn signals. One clip on each side that is similar to above, but hidden.
6. Pull the grill forward from the top, and as you do the bottom clips should release. Put the grill aside for now.
7. Unscrew headlight housings.
8. Change fog lamp bulbs.
9. Reverse steps 1-8 to reinstall grill.
There are several reasons for learning this procedure on your Jeep.
- changing fog light bulbs
- blacking out your headlights
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=55424- gutter guard mod for grill
- easy access to the engine oil filter through the drivers side headlight area
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=81051
_________________
2008 Liberty Sport 4x4 Automatic
Jeepin By Al 4" Lift Kit
BFG KO2’s 245/75R16
Full MOPAR skid plates
Rock Lizard Skink Super Sliders
AtTheHelm Front Recovery System & Roof RackM116A3 Trailer build thread: viewtopic.php?f=72&t=77997