Well here is the Pic.
Not sure what they go to...
Here is a link to a Vid for a KA core.
It it not complete but the KA and KK are very similar. Maybe you can find them in the Vid.
https://www.youtube.com/watch?v=SzaIrL1UiMQ
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Help!!! Just did heater core have leftover bolts http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=87608 |
Page 1 of 1 |
| Author: | Sandslinger17 [ Wed Dec 27, 2017 8:47 pm ] |
| Post subject: | Help!!! Just did heater core have leftover bolts |
Hey guys, I just did the heater core in the wife’s kk, what a pita! Anywase I got it all buttoned up getting ready to put trim in and the center console etc. I have two bolts that are unaccounted for. Can anyone tell me what these are for?? Thanks for any help! Here’s the link to the pic, copy and paste into search bar. Not very tech savvy haha https://ibb.co/jhcc7G |
|
| Author: | Scar0 [ Fri Dec 29, 2017 2:40 am ] |
| Post subject: | Re: Help!!! Just did heater core have leftover bolts |
Well here is the Pic. Not sure what they go to... Here is a link to a Vid for a KA core. It it not complete but the KA and KK are very similar. Maybe you can find them in the Vid. https://www.youtube.com/watch?v=SzaIrL1UiMQ |
|
| Author: | ajohns1288 [ Fri Dec 29, 2017 11:21 pm ] |
| Post subject: | Re: Help!!! Just did heater core have leftover bolts |
Look through here: viewtopic.php?f=104&t=84546 They look like they are either from the side bracket or the ones that bolt the IP to the HVAC box. What size are they? 13mm head will be the side bracket. |
|
| Author: | Fabricater [ Mon Jan 08, 2018 5:21 pm ] |
| Post subject: | Re: Help!!! Just did heater core have leftover bolts |
Scar0 wrote: Well here is the Pic. Not sure what they go to... Here is a link to a Vid for a KA core. It it not complete but the KA and KK are very similar. Maybe you can find them in the Vid. https://www.youtube.com/watch?v=SzaIrL1UiMQ I just did this job , I have the same bolts left over.they go just under the radio ,above the bracket that the console has to be removed to get to.that bracket has 2 studs with nuts that have to be removed.just a couple inches above those studs are 2 holes these bolts go in. Just remove the center trim piece and you should be able to put them in.on my son's 08,this puts them just behind the heater control knobs. |
|
| Author: | Fabricater [ Mon Jan 08, 2018 5:33 pm ] |
| Post subject: | Re: Help!!! Just did heater core have leftover bolts |
I have a problem with my traction control and ESP warning lights coming on. I am sure that I missed a connector somewhere, but not sure where to start looking under the dash. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|