srk9 wrote:
Looking for a parasite draw pulled fuses 1 at a time and replaced in same location I pulled them from. Went to try and start all dash lights work when turning key to run location nothing happens when turned to the start location no click nothing. Doing research I can pull the starter relay run 12volt power to the pin and starter will spin so starter is good. swapped relays still nothing. Battery load tested it is good. Pulled ALL fuses and did a continuity test all good. read about the ignition problem bought and installed new ignition just the wiring part not the key part still nothing. The little black plastic rod was still intact so it's not broken. At a total loss if no answer it gets towed to Jeep dealer
What year model? Any OBD codes?
Have you tried starting it in Neutral instead of Park?
In the Power Distribution Center under the hood:
When you turn the ign switch to the "ON/RUN" position, do you have 12v power on both sides of fuse #28?
If you don't, problem is in your ign switch or the mechanical rod that operates it.
With Ign switch in the "ON/RUN" position and fuse #28 confirmed good, you should have 12v power on terminal #86 (pin 6) at the starter relay plugin.
With Ign switch in the "ON/RUN" position, and you jump across connectors 30 to 87 (pins 9 to 10) at the starter relay, does the starter spin and engage and start the engine?
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve