| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Cam & crankshaft position sensors http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=88&t=92563 |
Page 1 of 1 |
| Author: | JeepMonkey190 [ Fri Jan 20, 2023 11:56 am ] |
| Post subject: | Cam & crankshaft position sensors |
Hey y’all just having some issues with the rough start after warm problem like a few others and I am going to try and just replace the fuel injectors and see if that resolves it due to no check engine light after it happens. But my question is about the cam and crankshaft position sensors… so when is it time to replace them? Do I wait for a check engine light or can I do the replacements as preventive maintenance? Thanks Also what about the ignition coils? Or anything else I should be looking at. 2011 KK with ~180k miles |
|
| Author: | layback40 [ Fri Jan 20, 2023 4:18 pm ] |
| Post subject: | Re: Cam & crankshaft position sensors |
Faulty sensors does not always throw a code. More likley to be a spark issue. |
|
| Author: | kiwi_outdoors [ Sat Feb 18, 2023 11:01 pm ] |
| Post subject: | Re: Cam & crankshaft position sensors |
is the throttle body clean? |
|
| Author: | JeepMonkey190 [ Sun Feb 19, 2023 2:15 pm ] |
| Post subject: | Re: Cam & crankshaft position sensors |
kiwi_outdoors wrote: is the throttle body clean? I haven’t checked but I did the fuel injectors and of the 6 new ones one was bad and throwing a code so had to do it again but now 6 new injectors and it has seemed to have vanished for now haven’t happened again since |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|