I have a 2012 JEEP LIBERTY SPORT 4X4 with the following:

COMMAND TRAC II - PART TIME 4WD
DANA 30/186MM FRONT AXLE
FOUR WHEEL DRIVE (4WD) (4X4)
3.73 REAR AXLE RATIO
CORPORATE 8.25 REAR AXLE
CONVENTIONAL DIFFERENTIAL REAR AXLE
4-SPD. AUTOMATIC VLP 42RLE TRANS

With approximately 98k miles, I’d like to change out the front axle fluid and would like to verify this would be the correct choice:
Valvoline Daily Protection Gear Oil / API Service GL-5 / 80W-90

FRONT AXLE / SAE 80W-90 Multi-Purpose Type, GL-5 Gear Lubricant or equivalent.
REAR AXLE / SAE 75W-90 Gear Lubricant or equivalent.

Thank-you!

_________________
Richard / 2012 Jeep Liberty Sport 4-wheel Drive

It will be fine. For my application in my KJ, I mix the two in a 60/40 ratio to get the best of both dino fluid and synthetic. As long as GL-5 your good to go.

_________________
05 CRD; Rebuilt top end w/ARP studs, EGR delete, SEGR, 3.7L HD cooling fan, Samco hoses, in tank pump, JBA coil overs & control arms, KK clevis fork, 1/2" cradle drop, 1/4" motor mount lift, WJ rear upper trilink w/WW mount, WJ lower control arms, 4:10 gear, front/rear air lockers, ARB bumper, Rock Lizard sliders/roof rack, Mod T-stat