isutherl wrote:
I have an 05' Renegade, One of the wheels has some corrosion, what can I do to stop it from spreading? Can I Just grind the spot down, polish it then put new clear coat over the spot?
Yes, that's it! Corrosion on the wheels! I have the same issue.
Some of that comes from the removal of old wheel weights. It takes off that plastic coating then the corrosion starts. I haven't tried the wet sanding which was suggestions in another area.
Here is a source for wheels some say they are cheap. But it's more that I want to spend. I would just like to clean up my wheels. From what I have found so far you need to sand the area down, paint it, then pain again with clear coat to stop the corrosion.
WHEEL COLLISION CENTER
7286 Penn Drive · Bath, PA 18014
Phone: (610) 837-8792 · Toll Free: (800) 292-RIMS
E-Mail: wccpa@erols.com
Homepage: http://www.wheelcollision.com
_________________
06 Jeep Liberty Limited CRD
Biodiesel when possible
1,300 Miles per AcreSynthetic Lubricants Specialists
http://www.lubedealer.com/ve