| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Closing the bigs holes in the engine bash plate? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=93&t=56075 |
Page 1 of 1 |
| Author: | Glend [ Wed Oct 06, 2010 11:32 pm ] |
| Post subject: | Closing the bigs holes in the engine bash plate? |
Does anyone know why that big oval shaped hole is in the engine bash plate? It's sole purpose seems to be allowing mud to pack in between the engine and the bash plate. I want to weld some plate over it and close it up. Can anyone think of any reason not to? |
|
| Author: | Fouros [ Thu Oct 07, 2010 1:59 am ] |
| Post subject: | Re: Closing the bigs holes in the engien bash plate |
i know i can drain my oil through it and not have to remove my engine skid |
|
| Author: | DirtyKK [ Thu Oct 07, 2010 2:03 am ] |
| Post subject: | Re: Closing the bigs holes in the engien bash plate |
Fouros wrote: i know i can drain my oil through it and not have to remove my engine skid Yep |
|
| Author: | Glend [ Thu Oct 07, 2010 2:44 am ] |
| Post subject: | Re: Closing the bigs holes in the engien bash plate |
No use on a CRD |
|
| Author: | DirtyKK [ Thu Oct 07, 2010 3:50 am ] |
| Post subject: | Re: Closing the bigs holes in the engien bash plate |
Glend wrote: No use on a CRD Well you could weld over it I suppose but I would put money on you still collecting plenty of mud. |
|
| Author: | Team J.a.G [ Thu Oct 07, 2010 10:40 pm ] |
| Post subject: | Re: Closing the bigs holes in the engien bash plate |
DirtyKK wrote: Glend wrote: No use on a CRD Well you could weld over it I suppose but I would put money on you still collecting plenty of mud. I generally drop mine down at every service or after a major sand or mud run, clean it out and get rid of that extra weight 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|